здравствуйте,вагами не занимаюсь но нужно помочь другу,при установке сигналки непоставил разьем на рульи появилось две ошибки: 00778 steering angle sensor not matcched и 01044 control module incorrectly coded ,подскажите по какому каналу нужно провести адаптацию

Вот что надыбал по твоей проблемме _



{Bremsenelektronik}



Steuerger

а хотябы на английском это можно???

00778 - Датчик угла поворота рулевого колеса-G85

01044 - Неправильно кодирован блок управления



Вот из эльзы по этой ошибке: Выставление 0-й позиции датчика



ESP, Electronic-Stability-Program Bosch 5.3

Steering angle sender -G85 zero position compensation

‒ Zero position compensation with the steering angle sender G-85 must now be performed.

‒ To initialise steering angle sender, turn steering wheel at least 10 degrees in any direction

‒ Move steering to zero position. Maximum tolerance ± 5 degrees

Note:



The diagnosis must not be terminated nor the ignition switched off between the procedures "Encoding control unit" and "Steering angle sensor compensation". Otherwise the entire process would have to be repeated.





→ Indicated on display: Rapid data transfer HELP

Select function XX



‒ Press 1 twice to select the function "Login procedure".





→ Indicated on display: Rapid data transfer Q

11 - Login procedure



‒ Confirm input with Q key.





→ Indicated on display: Login procedure Q

Enter code number XXXXX



‒ Enter code number 40168 and confirm entry with Q key.





→ Indicated on display: Rapid data transfer HELP

Select function XX



‒ Press keys 0 and 4 to select function "Basic setting".





→ Indicated on display: Rapid data transfer Q

04 - Basic setting



‒ Confirm input with Q key.





→ Indicated on display: Basic setting Q

Enter display group number XXX



‒ Press keys 0, 0 and 1 and confirm entry by pressing Q.





→ If this display appears, this means the function "Login procedure" has not been performed successfully. Function unknown or cannot ⇒

be carried out at present.







→ Indicated on display: System in basic setting 1⇒

Steer. angle sender compens. OK



‒ Check zero position using function 08 "Read measured value block", display group 5,

Or:





→ Indicated on display: System in basic setting 1⇒

Steer. angle sender compens. not OK



‒ Interrogating fault memory

‒ Erase fault memory

‒ Switch ignition off.

‒ Switch the ignition on.

‒ Perform zero position compensation again.

‒ Go back to the initial settings of the program by pressing the ⇒ key:





→ Indicated on display: Rapid data transfer HELP

Select function XX



Or:





→ Indicated on display: System in basic setting 1⇒

Steer. angle sender compens. Disabled



If initialising the steering wheel has not been carried out, the steering wheel must be turned at least 10 degrees in any direction.



‒ Switch ignition off.

‒ Switch the ignition on.

‒ Perform zero position compensation again.

‒ Go back to the initial settings of the program by pressing the ⇒ key:





→ Indicated on display: Rapid data transfer HELP

Select function XX

вот теперь гораздо понятнее,огромное спасибо а то по немчуре я ни бум бум http://www.carcd.ru/forum/public/sty...IR#>/smile.gif